1. When debugging a precision CNC lathe, you must set the G00 speed selector switch to F0 to allow the tool to approach the workpiece at a slower speed. Otherwise, once the tool offset is wrong, the tool will move extremely quickly from the tool change point in G00 mode. When approaching the tool entry point, there may be a strong collision with the workpiece, leaving the operator at a loss and too late to eliminate the danger; on the contrary, when the tool is approached at a slower speed, even if the tool deviation is wrong, the operator has plenty of time to adjust .

2. When debugging the program, the fully automatic CNC lathe must be in a single-step execution state. After the operator executes the previous block, he must check the correctness and rationality of the next block again, and make adjustments accordingly.

3. During the movement, the operator must always observe the change of the tool coordinates on the screen and whether the coordinates of the movement end point in the program are consistent with the coordinates of the actual movement of the tool.

4. During the debugging process of the automatic CNC lathe program, the operator can put one finger on the cycle start button and the other finger on the side of the cycle hold button, so that the execution of the program can be stopped in an emergency. Keep in mind the location of the emergency button at all times, so that it is needed from time to time. When starting the machine tool, it is generally necessary to set the economical CNC lathe reference point. The workpiece coordinate system of the machine tool should be consistent with the programmed coordinate system. If an error occurs, the turning tool may collide with the workpiece. In addition, the setting of tool length compensation must be correct, otherwise, it is either empty machining or collision.

1. Professional ethics, hard work 2. Proficiency in various operations and programming. Be able to correctly and proficiently perform various operations on the CNC machine tools for which you are responsible, and be proficient in programming methods, and be able to compile correctly optimized processing procedures to avoid machine failures caused by collisions caused by operating errors or programming errors. 3. In-depth understanding of machine tool characteristics and master the laws of machine operation. Have a deeper understanding of the characteristics of the machine tool, and be able to explore and grasp the operating conditions and certain laws, and the daily maintenance and maintenance work performed by the operator can be completed correctly and skillfully, so as to maintain the good condition of the machine tool. 4. Familiar with the operating procedures and the content of maintenance and inspection. You should be familiar with the basic operating procedures and safe operating procedures of the machine tool, the content of daily maintenance and inspection and the standards reached, the specific parts and requirements of maintenance and lubrication, and the oil (grease) brand and substitute oil (grease) used by the machine tool The normal pressure of the brand, hydraulic and pneumatic system. 5. Deal with it carefully and keep a record. All abnormal situations and signs found during operation can be carefully dealt with and recorded. Once a fault occurs, it should be dealt with in a timely and correct manner, and repair personnel should be found as soon as possible. During the repair process, closely cooperate with the maintenance personnel. Jointly complete the diagnosis and repair of machine tool faults. -----Fully automatic CNC lathe manufacturer